Applications — Data Communication — Waterproof Connector Manufacturer Since 2002

高速数据：RJ45 CAT6A、USB 与 M8

Built by YXY — waterproof connector manufacturer since 2002 · 东莞工厂

10Gbps-ready interconnects for telecom CPE, 5G small cells, FTTx ONU, data centers and industrial Ethernet. YXY builds shielded RJ45 CAT6A with PoE++, waterproof USB Type-C with 100W PD and compact M8 D-Code Ethernet — engineered for 500 MHz signal integrity, low crosstalk and IP68 field reliability from −40°C to +85°C.

获取报价查看产品

性能包络

决定链路性能的关键数据

数据来自 100% 全批次测试的最差极限值 — 而非规格书的典型值。每批发货均附批次追溯码与信道测试摘要。

10 GbpsCAT6A @ 500 MHz

PoE++ 100W支持 IEEE 802.3bt

NEXT > 65 dB@ 100 MHz

IP681.5 m / 2 h 插合状态

推荐系列

为通信不间断运行打造的三个数据系列

YXY 覆盖运营商网络接入户外的最后 20 米：抱杆式 ONU、屋顶小基站、街道机柜交换机与 IP67 边缘网关。所有系列均采用纯铜接触件、PA66 / 锌合金外壳，并按批进行 100% 导通、耐压与 IPX8 测试。

IP68 Waterproof RJ45 CAT6 Shielded Dual-Port Panel Mount Coupler

RJ45 IP68 CAT6A — Field & Panel Mount

Shielded 8P8C with die-cast Zn hood and 360° EMC continuity. Inline coupler, panel-mount bulkhead (M25 thread) and toolless field plug for ODU-to-IDU, outdoor PoE switches, FTTx wall boxes and top-of-rack patching where dust and hose-down matter.

10GBASE-T / 500 MHz，向下兼容 Cat6，支持 PoE / PoE+ / PoE++ Type 4（100W）
Toolless IDT: 22–24 AWG solid or stranded, T568A/B, re-enterable, under 60s termination
IP68 1.5 m / 2 h mated, −40 to +85°C, 1,000 mating cycles, >750 V AC hi-pot

了解 RJ45 CAT6A 系列

USB Type-C 防水 — 10 Gbps + 100W PD

IP67 panel receptacle plus overmolded cable for 5G CPE, outdoor Wi-Fi 6/6E APs, industrial gateways and test jigs. USB 3.2 Gen2 10 Gbps with USB 2.0 fallback and PD 3.0 up to 100W; screw-lock or magnetic latch, front or rear panel mount with gasket.

10 Gbps（可按要求配 E-marker 达 20 Gbps），5 A / 48 V PD，VBUS 额定 10,000 次
90 Ω differential impedance ±7%, <−35 dB crosstalk @ 5 GHz, double-shielded braid
IP67 mated, IPX5 unmated with cap, −30 to +85°C, salt fog 48 h

了解 USB Type-C 系列

M8 数据 — 紧凑型工业以太网

For distributed sensors, LiDAR, AMR fleets and compact switches where an RJ45 will not fit. A-code 3–4 pin for 100 Mbps / PoE-light and D-code 4 pin for 1000BASE-T on Cat5e; M8×1 screw thread, shielded PUR cable, IP67 mated, 2 m pigtails or panel jack.

D-Code 1 Gbps on Cat5e; A-code 100 Mbps; 4 A / 60 V contact rating
Ø12 mm body, Ø8 mm panel cutout, 360° shield ring, vibration per IEC 60068-2-6
PUR / TPE cable 22–24 AWG, double shield, 5M flex life, oil resistant, −40 to +85°C

了解 M8 数据系列

工程规格对照表

Speed, shielding & PoE — picked for carrier deployment

All values are production-measured on 100% lot-tested parts. We publish worst-case batch limits, not typicals. PoE temperature rise is quoted at 25°C ambient with 2-pair heating per IEEE 802.3bt.

参数	RJ45 IP68 CAT6A	USB Type-C 防水	M8 数据（A / D 型编码）
数据传输速率	10GBASE-T / 500 MHz （Cat6A）；Cat6 模式下 1 Gbps；100W PoE++ 不影响吞吐量	USB 3.2 Gen2 10 Gbps （兼容 Gen1 5 Gbps）；可降级至 USB 2.0 HS 480 Mbps	D 型编码：1000BASE-T（1 Gbps）; A-code: 100BASE-TX (100 Mbps), 2–4 wire
屏蔽 / EMC	360° Zn-alloy shell + foil/braid STP; shield DC < 20 mΩ; coupling attenuation > 60 dB	Full metal shell + double braid; <−35 dB near-end crosstalk @ 5 GHz; 90 Ω differential	Shield ring + braided cable; coupling > 45 dB; D-code shielded-pair twist 12 mm
PoE 供电能力	PoE / PoE+ / PoE++ Type 4 (90–100W) at the PSE; 2.5 A per contact, ΔT < 25°C @ 2 A	USB PD 3.0 最高 100W (20 V / 5 A) via E-marker; PPS on request; power + data simultaneous	A-code 4P: PoE-light 1 A / 30W max; D-code not for PoE (use a separate M8 power connector)
插入损耗 / 回波损耗	插入损耗 < 0.2 dB @ 250 MHz；回波损耗 > 18 dB @ 100 MHz、> 12 dB @ 500 MHz（符合 TIA-568.2-D）	IL < 1.5 dB @ 5 GHz; RL > 12 dB @ 5 GHz; eye-mask pass per USB-IF compliance	D-code: IL < 0.4 dB @ 100 MHz; RL > 16 dB; A-code contact resistance < 30 mΩ
串扰（NEXT / FEXT）	NEXT > 65 dB @ 100 MHz and > 45 dB @ 500 MHz; PSANEXT / PSAACRF compliant for 10G	Differential NEXT < −32 dB @ 10 GHz; intra-pair skew < 8 ps	D-code NEXT > 50 dB @ 100 MHz; pair-to-pair > 48 dB
电流 / 电压	1.5 A per contact continuous (8P), 125 VAC / 48 VDC PoE; dielectric 1000 VAC / 60 s	VBUS 5 A / 48 V，CC / SBU 1.25 A；耐压 500 VAC；CC 上拉 56 kΩ ±5%	4 A / 60 V (A-code), 4 A / 50 V (D-code); proof voltage 1500 VAC
Sealing & temperature	IP68 1.5 m / 2 h mated, IPX8 cable gland; −40 to +85°C; UV and salt fog 96 h	IP67 mated, IPX5 unmated with cap; −30 to +85°C; 10,000 insertion cycles	IP67 mated, IP65 unmated with cap; −40 to +85°C; 200 mating cycles minimum
Cable & field use	22–26 AWG 实心 / 绞合线，外径 5.0–9.0 mm，免工具 IDC，可重复使用 3 次	Overmolded PUR / LSZH, OD 3.5–6.0 mm, screw-lock 4.5 kgf retention	PUR / TPE, OD 4.8–6.2 mm, double shielded, 5M flex cycles

注意：10G 链路需要完整的 Cat6A 信道（90 m 永久链路 + 跳线）。YXY 可按批次要求提供 Fluke DSX-8000 信道测试报告。PoE++ 热设计指导 — 包括 8 端口共用同一壳体时的降额 — 详见规格书。

现场挑战

10 Gbps integrity & crosstalk — where most connectors lose the link

通信产品的现场失效很少只是防水问题：500 MHz 下的近端串扰、线束中的外来串扰、面板开孔处的屏蔽层断裂，以及密封盒体内的 PoE 发热。YXY 针对这四点逐一设计规避。

1. 在真实户外信道上稳定 10 Gbps

Cheap RJ45 jacks add 1–2 dB of return loss at 400 MHz. One bad insertion and the link auto-negotiates down to 1G — invisible in the lab, fatal on a 60 m CPE run. YXY uses compensated contact geometry and tuned pair spacing for RL > 12 dB @ 500 MHz and IL < 0.2 dB, and every lot ships with a Fluke DSX-8000 channel summary (NEXT / RL / IL). Lots that pass only on typical are rejected. For any run over 30 m, or bundles inside a cabinet, we specify Cat6A STP — our BOM guidance treats Cat6 UTP as 1G-only.

2. 密集机柜中的串扰与外来串扰

Eight 10G ports in a street cabinet are ANEXT-limited: unshielded plastic jacks radiate and one bundle can kill the margin on its neighbor. The 360° zinc shell stitches to the cable braid through an 8-spring collet, holding seam impedance under 20 mΩ even after 200 mating cycles. An internal pair separator plus staggered IDC keeps PSANEXT above 65 dB @ 100 MHz — verified in a 6-around-1 bundle. For 12+ port blocks we recommend 15 mm edge-to-edge jack spacing or a shielded patch panel.

3. 面板处屏蔽层不连续与 PoE 发热

A panel-mount jack that does not bond to the enclosure is an antenna. And 100W PoE++ inside an IP68-sealed CPE box heats the contacts — the wrong contact alloy drifts 15°C above ambient. YXY panel jacks use a serrated flange with grounding teeth that cut through paint and bond to sheet metal under 5 mΩ, no scraping required. Phosphor-bronze C5210 contacts with 50 µ" gold plating hold ΔT < 25°C @ 2 A per pair (measured at 25°C ambient), and we supply thermal derating curves for 4-pair bundles inside enclosures.

4. 密封不等于牺牲信号或 USB PD

An O-ring in the wrong place compresses the twisted pairs and adds skew; USB panel gaskets that protrude 0.5 mm break impedance and kill SuperSpeed. The RJ45 triple-seal (cable gland + inner silicone ring + face gasket) keeps the seal outside the signal cavity. The USB Type-C uses a recessed 0.3 mm co-planar gasket with shielded overmold, maintaining 90 Ω even mated with the IP67 cap. Every batch is verified with IPX8 soak, T568B continuity and a live 10G link test after 10 thermal shocks from −40 to +85°C.

开始您的定制

需要能扛住机柜与风暴的 10 Gbps？

发送您的面板厚度、线缆外径、端口数量与目标 PoE 负载。我们将在 24 小时内回复匹配的 YPM20 / USB-C / M8-D 建议、DSX 报告摘要、STEP 文件与阶梯报价 — 并附 48 小时出样计划。

获取报价微信：WaheedAnogh

YXY Electronics · Building 2, Dushi Valley, Fenggang Town, Dongguan · 12 SMT & molding lines · ISO9001 / IATF16949 · UL / CE / RoHS / REACH · 200M+ assemblies per year
或发送邮件 waheed@yxydz.com · MOQ 10 pcs · STEP / DSX sample on request